欢迎进入东莞市安泰科精密五金有限公司网站
全国服务热线
0769-83885215
热点资讯
切削参数,齿距的换算
径节滚花-换算表
时间: 2018-12-18 15:33 浏览次数:
Blank diameters for diametral pitch knurling dies are more easily computed, since they are always common fractional sizes. The formula is as follows: Blank Diameter = ( #Teeth [part] / Diametral Pitch ) American Standard ANSI B94.6-1984 des

相司径节的工件因为与滚花轮的齿节距相同,所以更容易计算,如下表:

Blank Diameter = ( #Teeth [part] / Diametral Pitch )
American Standard ANSI B94.6-1984 describes the diametral pitch knurl system. Diametral pitch knurls are designed to track uniformly on fractional size stock up to 1" in multiples of 1/32" or 1/64". They are held to closer tolerances for this purpose.

The American Standard recommends that the use of 64 Diametral Pitch knurls be avoided as much as possible, and that preference be given to the use of 96 D.P. knurls for simplification of tooling. (For Equivalent Normal Circular TPI see below.)

The number of teeth that will be rolled can be easily determined by multiplying the blank diameter by the Diametral Pitch of the knurl. Example: A 96 D.P. knurl will roll 96 x 1/2 = 48 teeth on a 1/2" diameter stock.

D.P.Blank Diameters for Uniform Tracking64every 1/64"96every 1/32" (also every 1/96")128every 1/64" (also every 1/128")160every 1/32" (also every 1/160")
D.P.Equivalent Normal Circular TPIStraight Teeth30° Diagonal6420.723.99630.835.612841.147.416051.259.1 

NOTE: Unfortunately the above formulas do not hold precisely for all conditions. Sometimes apparently identical knurls from different manufacturers will not track on the same blank diameters due to a difference in the sharpness of the teeth. Also, it is possible for the number of teeth rolled on a part to change as the knurling tool wears. How deeply the knurl penetrates into the work blank on the first revolution is the main factor in determining if an adjustment should be made to the basic formula.

Some factors which affect this penetration are:
  1. In-feed rate (or axial feed rate for knurling from the turret)

  2. Sharpness of the knurl teeth

  3. Hardness of the material

  4. Included tooth angle of the knurl (a sharper angle pentrates easier)

  5. Width of knurl face (a narrow face penetrates easier)

  6. Method of knurling (bump from cross-slide or end knurling from turret)

  7. Bevels on edges of part or knurl tool (affects knurl penetration from end)

A change in any of the above variable may correct (or cause) a mis-tracking problem.         


Copyright © 2018 东莞市安泰科精密五金有限公司 版权所有      备案号:
全国服务电话:0769-83885215     传真:0769-83971520
地址:广东省东莞市常平镇苏坑乐园路14号

客服
电话
服务电话:
0769-83885215
微信

微信公众号